Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011COMPASS 4WD L4-2.4LREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYSERVICE AND REPAIRA/C AND HEATER CONTROL - INSTALLATION
2011 Jeep Compass 4WD L4-2.4L
A/C And Heater Control - Installation
2011 Jeep Compass 4WD L4-2.4LSECTION A/C And Heater Control - Installation
INSTALLATION
NOTE: Take the proper precautions to protect the front face of the center bezel from cosmetic damage while performing this procedure.
NOTE: MTC A/C-heater control shown. ATC A/C-heater control similar.
1. Position the A/C-heater control (2) onto the back of the center bezel (3).
2. Install the four screws (1 and 4) that secure the A/C-heater control to the bezel. Tighten the screws to 2 Nm (17 in. lbs.).
3. Install the center bezel Instrument Panel Bezel - Installation.
4. Reconnect the negative battery cable.
NOTE: When installing a new A/C-heater control, or reinstalling the original control, the A/C-heater control will automatically run the Actuator Calibration function when the ignition switch is initially turned to ON. However, the Actuator Calibration function must be manually initiated using a scan tool if the A/C-heater control was previously installed in another vehicle.
5. If required, initiate the Actuator Calibration function using a scan tool .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.