Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2011COMPASS 2WD L4-2.0LPARTS AND LABORENGINE, COOLING AND EXHAUSTENGINELABOR TIMES
2011 Jeep Compass 2WD L4-2.0L
Engine: Labor Times
2011 Jeep Compass 2WD L4-2.0LSECTION Labor Times
| Standard Hours | Manufacturer Warranty Hours | Skill Level | Notes | |
| Diagnose/Test | ||||
| Oil Leak, Diagnosis | 1.0 | 0.0 | B | |
| Replace | ||||
| Complete Assembly Without Transfer Of Parts | 11.7 | 0.0 | B | Includes: Transfer Of All Fuel & Electrical Units. Does Not Include: Transfer Of Optional Equipment. |
| NOTE | ||||
| With 4WD, Add | 0.9 | 0.0 | B | |
| Complete Assembly With Transfer Of Parts | 14.7 | 10.3 | B | Includes: Transfer Of All Fuel & Electrical Units. Does Not Include: Transfer Of Optional Equipment. |
| NOTE | ||||
| With 4WD, Add | 0.9 | 0.0 | B | |
| Long Block | 18.2 | 7.9 | B | Includes: R&I Engine And Replacement Of All Necessary Components. |
| NOTE | ||||
| With 4WD, Add | 0.9 | 0.7 | B | |
| Short Block | 20.2 | 10.5 | A | Includes: R&I Engine And Replacement Of All Necessary Components. |
| NOTE | ||||
| With 4WD, Add | 0.9 | 0.7 | A | |
| Overhaul/Rebuild | 28.2 | 0.0 | A | Includes: Disassemble & Clean Engine, Ridge Ream & Hone Cylinders, Fit Pistons, Rings, Pins, Main & Rod Bearings, Grind Valves & Tune-Up. |
| NOTE | ||||
| With 4WD, Add | 0.9 | 0.0 | A |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.