2010 Jeep Liberty Renegade, Part TimeFACTORY OEM SERVICE PROCEDURE

Diagnostic Test

  1. VERIFICATION TEST 
    1. Remove any special tools or jumper wires and reconnect all previously disconnected components - except the battery.
      WARNING: Turn the ignition on, then reconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
    2. Connect the scan tool to the Data Link Connector - use the most current software available.
    3. With the scan tool to erase stored DTCs in the Occupant Classification Module (OCM) DTCs.
    4. Turn the ignition off, and wait five seconds, then turn the ignition on.
    5. Wait one minute, using the scan tool read active OCM DTCs and if there are none present read the stored codes.
    6. If the scan tool shows any active or stored codes, follow path specified for that trouble code. If no active or stored codes are present, the repair is complete.

      Are any DTCs present or is the original condition still present?

      Yes 

      No 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.