Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Jeep Compass Limited, EDG, StandardFACTORY OEM SERVICE PROCEDURE
DTC Index
Select a section or procedure below to view factory instructions:
ABS - Electrical DiagnosticsAirbag - Electrical DiagnosticsAll Wheel Drive (AWD) Module - Electrical DiagnosticsAudio (Amplifier) - Electrical DiagnosticsAudio (Radio) - Electrical DiagnosticsCabin Compartment Node (CCN) - Electrical DiagnosticsHands Free Module (HFM) - Electrical DiagnosticsHeating & Air Conditioning - Electrical DiagnosticsIntrusion Transceiver Module (ITM) - Electrical DiagnosticsPowertrain Control Module (PCM) - Gas - Electrical DiagnosticsTotally Integrated Power Module (TIPM) - Electrical DiagnosticsTransmission Control Module (TCM) - Electrical Diagnostics
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.