2010 Jeep Commander Limited, RWDFACTORY OEM SERVICE PROCEDURE

MODULE, Memory: Removal: Removal

Fig 1: Removing/Installing Memory Seat Module
GC0118366Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the driver seat cushion/cover (2). Refer to Body/Seats/COVER, Seat Cushion - Removal .
  3. Pivot the module upward and disconnect the electrical connectors (1).
  4. Unsnap the memory seat module (4) from the side brackets.
  5. Pull the module rearward to remove it from the front of the seat frame (3).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.