SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009WRANGLER 2WD V6-3.8LREPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SWITCHSERVICE AND REPAIRSPEED CONTROL SWITCH - INSTALLATION
2009 Jeep Wrangler 2WD V6-3.8L

Speed Control Switch - Installation

2009 Jeep Wrangler 2WD V6-3.8LSECTION Speed Control Switch - Installation





INSTALLATION





Mounting hole (1) uses a screw. Depending on model line, mounting holes (2) may use either two screws, or one screw and a locating pin.





1. Connect electrical connector to speed control switch.
2. Install speed control switch mounting screws.
3. Tighten screws (1) to 1.6 Nm (15 in. lbs.). Make sure rubber seal is in place around switch.





4. Install horn switch.
5. Install three mounting fasteners.
6. Connect electrical connector to clockspring.
7. Install driver airbag. Driver Air Bag - Installation

WARNING: Do not connect battery negative cable yet. Refer first to airbag system test. Testing and Inspection

8. Reconnect battery using Airbag System Test procedure in Restraints. Testing and Inspection
9. Close hood.
10. Verify vehicle and system operation.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.