Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009PATRIOT 4WD L4-2.4LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSFUEL LEVEL SENSORSERVICE AND REPAIRFUEL PUMP MODULE - INSTALLATION
2009 Jeep Patriot 4WD L4-2.4L
Fuel Pump Module - Installation
2009 Jeep Patriot 4WD L4-2.4LSECTION Fuel Pump Module - Installation
AWD
NOTE: The pump has to be properly located to the tank for the fuel gauge to work properly.
1. Wipe seal area of tank clean. Place a new seal between the tank threads and the pump module opening.
2. Connect line to module.
3. Install fuel pump module.
4. Position fuel pump module in tank. Make sure the alignment tab lines up on the fuel tank and pump module for Gas or Diesel fuel tanks.
5. While holding the pump module in position, install lock ring and use special tool Lock Ring #9340 to tighten lock ring.
6. Install plastic cover.
7. Connect electrical connector (2).
8. Install rear cushion.
9. Install the negative battery cable.
10. Fill fuel tank with clean fuel. Use the Scan Tool to pressurize the system and check for leaks.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.