Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009LIBERTY 4WD V6-3.7LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTTRANSMISSION CONTROL SYSTEMSRELAYS AND MODULES - TRANSMISSION AND DRIVETRAINRELAYS AND MODULES - TRANSFER CASECONTROL MODULESERVICE AND REPAIRFINAL DRIVE CONTROL MODULE - INSTALLATION
2009 Jeep Liberty 4WD V6-3.7L
Final Drive Control Module - Installation
2009 Jeep Liberty 4WD V6-3.7LSECTION Final Drive Control Module - Installation
INSTALLATION
1. Connect the two electrical connectors (1) into the FDCM.
2. Install the FDCM being certain the locking tabs (1) are secure.
3. Raise the drivers side knee bolster.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.