Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009GRAND CHEROKEE 4WD V8-5.7LREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - POWER AND GROUND DISTRIBUTIONPOWER DISTRIBUTION MODULESERVICE AND REPAIRPOWER INVERTER MODULE - INSTALLATION
2009 Jeep Grand Cherokee 4WD V8-5.7L
Power Inverter Module - Installation
2009 Jeep Grand Cherokee 4WD V8-5.7LSECTION Power Inverter Module - Installation
INSTALLATION
NOTE: If a new inverter module is being installed, the mounting bracket will need to be transferred from the old module to the new.
1. Install the inverter module (4) onto the mounting bracket assembly (5).
2. Position the module and bracket onto the rear seat frame. Line up the mounting tabs (3) with the slots in the seat frame (2).
3. Push the module forward to engage the mounting tabs and install the fastener (1).
4. NOTE: Ensure the module electrical connector is connected during seat installation.
Install the rear seat assembly, Seat - Installation.
5. Connect the battery negative cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.