Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009GRAND CHEROKEE 2WD V8-4.7LREPAIR AND DIAGNOSISPOWER AND GROUND DISTRIBUTIONPOWER DISTRIBUTION MODULESERVICE AND REPAIRPOWER INVERTER MODULE - REMOVAL
2009 Jeep Grand Cherokee 2WD V8-4.7L
Power Inverter Module - Removal
2009 Jeep Grand Cherokee 2WD V8-4.7LSECTION Power Inverter Module - Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the rear seat cushion assembly, Seat Back - Removal.
3. Remove the fastener (1) from the inverter module mounting bracket of the (5).
4. Slide the module rearward to release the mounting tabs (3) from the slots in the seat frame (2).
5. Remove the inverter module (4).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.