Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Jeep Compass 2WD L4-2.4LFACTORY OEM SERVICE PROCEDURE
Control Assembly: Description and Operation
DESCRIPTION
NOTE: Typical A/C-heater control shown.
The A/C-heater control (1) for the manual temperature control (MTC) single zone system allows one temperature setting for the entire vehicle. All controls are identified by ISO graphic symbols.
The heating-A/C system uses a combination of electrical and cable operated controls. These controls provide the vehicle operator with a number of setting options to help control the climate and comfort within the vehicle.
The A/C-heater control is located in the instrument panel and contains:
- a rotary control for mode control of the discharged air (2).
- a rotary control for blower motor speed selection and to turn the blower motor off (3).
- a rotary control for temperature control of the discharged air (4).
- a push-button control to turn the rear window defogger system on and off (5).
- a push-button control for recirculation control of the discharged air (6).
- a push-button control to turn the A/C system on and off (7).
The A/C-heater control cannot be repaired or adjusted and it must be replaced if found inoperative or damaged. The control knobs for the A/C-heater control are available for service replacement.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
