Restraints System (Service Information): Specifications: Specifications

2009 Jeep Commander Sport, 3.7 K, AWDSECTION Specifications
SPECIFICATIONS

DESCRIPTION N.m Ft. Lbs. In. Lbs.
Clockspring Mounting Screws 3 - 27
Curtain Airbag Inflator Bracket Mounting Screws 6 - 50
Curtain Airbag Mounting Screws 6 - 50
Driver Airbag Mounting Screws 10 - 90
Front Impact Sensor Mounting Nuts 8 - 70
Side Impact Sensor Mounting Screws 6.5 - 60
Occupant Restraint Controller Mounting Screws 14 10 -
Passenger Airbag Mounting Screws 12 - 105
Front Seat Belt Buckle Lower Anchor Mounting Nut 43 32 -
Second Row Seat Belt Buckle Anchor Bracket Mounting Screws 50 37 -
Second Row Center Seat Support Bracket/Striker Trim 3 - 28
Front Seat Belt Retractor Mounting Screw 39 29 -
Front Seat Belt Turning Loop Mounting Screw 39 29 -
Front Seat Belt Lower Anchor Mounting Screw 39 29 -
Second Row Outboard Seat Belt Retractor Mounting Screw 39 29 -
Second Row Outboard Seat Belt Turning Loop Mounting Screw 39 29 -
Second Row Outboard Seat Belt Lower Anchor Mounting Screw 50 37 -
Second Row Center Retractor Mounting Screw 50 37 -
Second Row Center Retractor Shield Mounting Screws 2 - 18
Second Row Center Seat Belt Lower Anchor Mounting Screw 50 37 -
Third Row Seat Belt Retractor Mounting Screw 43 32 -
Third Row Seat Belt Retractor Retainer Bracket Through Bolt 43 32 -
Third Row Seat Belt Escutcheon Mounting Screws 3 - 28
Third Row Seat Belt Lower Anchor Mounting Screw 43 32 -
Seat Belt Turning Loop Adjuster Mounting Screws 39 29 -
Seat Track Position Sensor Mounting Screw 2 - 15
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.