Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009COMMANDER OVERLAND, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 25 (ELECTRONIC CONTROL MODULES (SERVICE INFORMATION))ELECTRONIC CONTROL MODULESMODULE-FINAL DRIVE CONTROLOPERATIONFINAL DRIVE CONTROL MODULENEUTRAL LAMP
2009 Jeep Commander Overland, RWD
Neutral Lamp
2009 Jeep Commander Overland, RWDSECTION Neutral Lamp
WARNING: This page is about a different car, the 2008 Jeep Commander. However, it is still accessible from the selected car via links, so may be relevant.
There will be a LED indicator in the Shifter bezel to indicate to the driver that the Transfer Case is in the Neutral gear. FDCM will be capable of driving the LED continuously at 25 mA.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.