Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009COMMANDER OVERLAND, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 25 (ELECTRONIC CONTROL MODULES (SERVICE INFORMATION))ELECTRONIC CONTROL MODULESMODULE-ENGINE CONTROLOPERATIONENGINE CONTROL MODULE (ECM)OVERSPEED DETECTION MODE
2009 Jeep Commander Overland, RWD
Overspeed Detection Mode
2009 Jeep Commander Overland, RWDSECTION Overspeed Detection Mode
WARNING: This page is about a different car, the 2008 Jeep Commander. However, it is still accessible from the selected car via links, so may be relevant.
If the ECM detects engine RPM that exceeds 5200 RPM, the ECM will set a DTC in memory and illuminate the MIL until the DTC is cleared.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.