Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009COMMANDER 4WD V8-5.7LREPAIR AND DIAGNOSISSTARTING AND CHARGINGPOWER AND GROUND DISTRIBUTIONPOWER DISTRIBUTION MODULESERVICE AND REPAIRPOWER INVERTER MODULE - REMOVAL
2009 Jeep Commander 4WD V8-5.7L
Power Inverter Module - Removal
2009 Jeep Commander 4WD V8-5.7LSECTION Power Inverter Module - Removal
REMOVAL
1. Disconnect the negative battery cable.
2. Remove the cup holder/bin (1) from the drivers side quarter panel (2).
3. Disconnect the harness push pins (1) from the power inverter bracket (2).
4. Remove the two forward retainers (1).
5. Remove the rear retainer (1).
6. Pull the power inverter up and disconnect the electrical connector.
7. Remove the power inverter from the mounting bracket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.