Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009COMMANDER 4WD V8-5.7LREPAIR AND DIAGNOSISBODY AND FRAMERELAYS AND MODULES - BODY AND FRAMEPOWER TRUNK / LIFTGATE CONTROL MODULESERVICE AND REPAIRPOWER LIFTGATE CONTROL MODULE - REMOVAL
2009 Jeep Commander 4WD V8-5.7L
Power Liftgate Control Module - Removal
2009 Jeep Commander 4WD V8-5.7LSECTION Power Liftgate Control Module - Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the left quarter trim panel from the vehicle, Quarter Trim Panel - Removal.
3. Disconnect the wire harness connectors (3) from the power liftgate control module (1).
4. Remove the power liftgate control module (1) from the left rear wheel well (2).
5. Remove the module (1) from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.