Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Satellite Video Module - Installation
2009 Jeep Commander 4WD V8-5.7LSECTION Satellite Video Module - Installation
INSTALLATION
1. Connect the antenna (1) and electrical connector (2) to module (3).
2. Install the receiver module.
3. Install and tighten mounting fasteners.
4. Install the carpeted cover panel from over the cavity on the right outboard end of the intermediate step assembly.
5. Connect battery negative cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.