SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009COMMANDER 4WD V8-4.7LREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTANTITHEFT AND ALARM SYSTEMSALARM MODULESERVICE AND REPAIRINTRUSION MODULE - INSTALLATION
2009 Jeep Commander 4WD V8-4.7L

Intrusion Module - Installation

2009 Jeep Commander 4WD V8-4.7LSECTION Intrusion Module - Installation





INSTALLATION





1. Position the intrusion module (2) into the cavity on the right outboard end of the intermediate step assembly (1) and insert the two mounting tabs on the sides of the module into the slots in the floor of the cavity.
2. Slide the module into the slots of the intermediate step cavity, until the two latch features integral to the cavity are fully engaged over the mounting tabs on the sides of the module.
3. Reconnect the body wire harness connector (3) to the module connector receptacle.
4. Reinstall the carpeted cover panel over the cavity on the right outboard end of the intermediate step assembly.
5. Restore the right outboard second row seat assembly to its normal seating position.
6. Reconnect the battery negative cable.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.