Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009COMMANDER 2WD V8-4.7LREPAIR AND DIAGNOSISSTARTING AND CHARGINGPOWER AND GROUND DISTRIBUTIONPOWER DISTRIBUTION MODULESERVICE AND REPAIRPOWER INVERTER MODULE - INSTALLATION
2009 Jeep Commander 2WD V8-4.7L
Power Inverter Module - Installation
2009 Jeep Commander 2WD V8-4.7LSECTION Power Inverter Module - Installation
INSTALLATION
1. Install power inverter into the mounting bracket.
2. Connect the power inverter electrical connectors.
3. Install the rearward retainer (1).
4. Install the two forward retainers (1).
5. Connect the harness push pin (1) to the power inverter bracket (2).
6. Instal the cup holder/bin (1) to the drivers side quarter panel (2).
7. Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.