Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMPASS LIMITED, FWD, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMDTCS P2118 TO P2305
2008 Jeep Compass Limited, FWD, Standard
DTCS P2118 To P2305
2008 Jeep Compass Limited, FWD, StandardSECTION DTCS P2118 To P2305
- P2118-Electronic Throttle Control Motor Current Performance
- P2119-Throttle Actuator Control Throttle Body Performance
- P2122-Accelerator Pedal Position Sensor 1 Circuit Low
- P2123-Accelerator Pedal Position Sensor 1 Circuit High
- P2127-Accelerator Pedal Position Sensor 2 Circuit Low
- P2128-Accelerator Pedal Position Sensor 2 Circuit High
- P2135-Throttle Position Sensor 1/2 Correlation
- P2138-Accelerator Pedal Position Sensor 1/2 Correlation
- P2161-Vehicle Speed Sensor 2 Erratic (With Abs)
- P2166-Accelerator Pedal Position Sensor 1 Maximum Stop Performance
- P2167-Accelerator Pedal Position Sensor 2 Maximum Stop Performance
- P2172-High Airflow / Vacuum Leak Detected (Instantaneous Accumulation)
- P2173-High Airflow / Vacuum Leak Detected (Slow Accumulation)
- P2174-Low Airflow / Restriction Detected (Instantaneous Accumulation)
- P2175-Low Airflow / Restriction Detected (Slow Accumulation)
- P2181-Cooling System Performance
- P2183-Engine Coolant Temperature Sensor 2 Circuit Performance
- P2184-Engine Coolant Temperature Sensor 2 Circuit Low
- P2185-Engine Coolant Temperature Sensor 2 Circuit High
- P2270-O2 Sensor 1/2 Signal Biased Lean
- P2271-O2 Sensor 1/2 Signal Biased Rich
- P2299-Brake Pedal Position / Accelerator Pedal Position Incompatible
- P2301-Ignition Coil 1 Circuit High
- P2302-Ignition Coil 1 Secondary Circuit-Insufficient Ionization
- P2304-Ignition Coil 2 Circuit High
- P2305-Ignition Coil 2 Secondary Circuit-Insufficient Ionization
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.