Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMPASS LIMITED, FWD, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMDTCS P0513 TO P0616
2008 Jeep Compass Limited, FWD, Standard
DTCS P0513 To P0616
2008 Jeep Compass Limited, FWD, StandardSECTION DTCS P0513 To P0616
- P0513-Invalid Skim Key
- P0522-Engine Oil Pressure Sensor Circuit Low
- P0523-Engine Oil Pressure Sensor Circuit High
- P0532-A/C Pressure Sensor Circuit Low
- P0533-A/C Pressure Sensor Circuit High
- P0562-Battery Voltage Low
- P0563-Battery Voltage High
- P0571-Brake Switch 1 Performance
- P0572-Brake Switch 1 Stuck On
- P0573-Brake Switch 1 Stuck Off
- P0579-Speed Control Switch 1 Circuit Performance
- P0580-Speed Control Switch 1 Circuit Low
- P0581-Speed Control Switch 1 Circuit High
- P0585-Speed Control Switch 1/2 Correlation
- P0591-Speed Control Switch 2 Circuit Performance
- P0592-Speed Control Switch 2 Circuit Low
- P0593-Speed Control Switch 2 Circuit High
- P0600-Serial Communication Link
- P0601-Internal Memory Checksum Invalid
- P0606-Internal ECM Processor
- P060B-Etc A-D Ground Performance
- P060D-Etc Level 2 App Performance
- P060E-Etc Level 2 TPS Performance
- P060F-Etc Level 2 ECT Performance
- P0615-Starter Control Circuit/Open
- P0616-Starter Control Circuit Low
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.