Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMPASS LIMITED, FWD, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMDTCS P0354 TO P0507
2008 Jeep Compass Limited, FWD, Standard
DTCS P0354 To P0507
2008 Jeep Compass Limited, FWD, StandardSECTION DTCS P0354 To P0507
- P0354-Ignition Coil 4 Circuit
- P0365-Camshaft Position Sensor Circuit-Bank 1 Sensor 2
- P0366-Camshaft Position Sensor Performance-Bank 1 Sensor 2
- P0369-Camshaft Position Sensor Intermittent-Bank 1 Sensor 2
- P0420-Catalyst 1/1 Efficiency
- P0440-General EVAP System Failure
- P0441-EVAP Purge System Performance
- P0443-EVAP Purge Solenoid Circuit
- P0444-EVAP Purge Solenoid Circuit Open
- P0452-EVAP Pressure Switch Stuck Closed
- P0455-EVAP System Large Leak
- P0456-EVAP System Small Leak
- P0457-EVAP System - Loose Fuel Cap
- P0458-EVAP Purge Solenoid Circuit Low
- P0459-EVAP Purge Solenoid Circuit High
- P0461-Fuel Level Sensor 1 Performance
- P0462-Fuel Level Sensor 1 Circuit Low
- P0463-Fuel Level Sensor 1 Circuit High
- P0480-Cooling Fan 1 Control Circuit
- P0481-Cooling Fan 2 Control Circuit
- P0501-Vehicle Speed Sensor 1 Performance
- P0501-Vehicle Speed Sensor 1 Performance (MTX Non-Abs)
- P0503-Vehicle Speed Sensor 1 Erratic (Exc MTX Non-Abs)
- P0503-Vehicle Speed Sensor 1 Erratic (MTX Non-Abs)
- P0506-Idle Speed Performance Lower Than Expected
- P0507-Idle Speed Performance Higher Than Expected
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.