Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Jeep Compass Limited, FWD, StandardFACTORY OEM SERVICE PROCEDURE
Installation-Gas Engine
| 1 - RADIATOR FAN ELECTRICAL CONNECTOR |
| 2 - BRACKET |
| 3 - RADIATOR |
- Install the radiator fan assembly into J-clips.
- Install radiator fan fasteners. Tighten all radiator fan retaining screws to 6 N.m (55 in. lbs.).
- Install radiator crossmember. Refer to INSTALLATION .
- Install wiring harness bracket (2).
- Connect radiator fan electrical connector (1).
- Install upper radiator hose.
- Connect negative battery cable.
- Fill cooling system. See STANDARD PROCEDUREΒ .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
