2008 Jeep Compass Limited, FWD, StandardFACTORY OEM SERVICE PROCEDURE

Master Cylinder-RHD

Fig 1: Air Cleaner Assembly
GC0053051Courtesy of CHRYSLER LLC
  1. Remove the engine cover.
  2. Remove air cleaner assembly (1).
  3. Disconnect battery negative cable.
    CAUTION: Brake fluid will damage painted surfaces. If brake fluid is spilled on any painted surfaces, wash it off immediately with water.
  4. Disconnect hydraulic supply tube to clutch master cylinder. To completely drain clutch master cylinder and tubing, remove brake master cylinder cap.
  5. Disconnect hydraulic tube and drain fluid into suitable container. Lower vehicle.
  6. Remove instrument panel bezel.
  7. Disconnect clutch master cylinder pushrod from clutch pedal.
    Fig 2: Master Cylinder
    GC0053110Courtesy of CHRYSLER LLC
  8. Disconnect clutch master cylinder supply line from brake master cylinder reservoir (6), Cap off or collect reservoir fluid spillage.
    Fig 3: Master Cylinder Pipe At Left Rail
    GC0022841Courtesy of CHRYSLER LLC
    1 - RETAINER
    2 - MASTER CYLINDER PIPE
  9. Remove hydraulic tube from left rail retainer.
    CAUTION: Use care when removing clutch master cylinder from engine compartment. Aggressive handling can result in a damaged hydraulic tube and improper clutch release operation upon reassembly.
  10. Release master cylinder by rotating to disengage from pedal bracket assembly.
    CAUTION: Use care when removing clutch master cylinder from engine compartment. Aggressive handling can result in a damaged hydraulic tube and improper clutch release operation upon reassembly.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.