2008 Jeep Compass Limited, FWD, StandardFACTORY OEM SERVICE PROCEDURE

Master Cylinder-RHD

Fig 1: Clutch Hydraulic System Components
GC0053107Courtesy of CHRYSLER LLC
  1. Install clutch master cylinder (1).
  2. Insert tube into master cylinder port and install retaining clip (5).
  3. Connect clutch master cylinder supply hose (2) to brake master cylinder reservoir (1).
  4. Verify that brake master cylinder reservoir is full and cap is off.
  5. Position clutch master cylinder body vertically, with pushrod pointing down, for about ten seconds to purge air trapped from end of cylinder.
  6. Install clutch master cylinder body to dash panel and 1/4 turn to secure.
  7. Connect clutch master cylinder rod to clutch pedal pin. An audible "click" should be heard.
  8. Install lower instrument panel bezel.
    Fig 2: Air Cleaner Assembly
    GC0053051Courtesy of CHRYSLER LLC
  9. Connect battery negative cable.
  10. Install air cleaner assembly (1).
  11. Verify that brake master cylinder reservoir is full. Top off with DOT 3 brake fluid if necessary.
  12. Bleed clutch system. See STANDARD PROCEDUREΒ .
  13. Actuate clutch pedal a minimum of fifteen times to allow any air ingested into the system to vent to the master cylinder reservoir. If residual air becomes trapped in the system, it is necessary to bleed the clutch hydraulic system.
  14. Verify proper clutch release system operation.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.