Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSJEEP2008COMPASS LIMITED, AWD, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCEFUEL DELIVERYFUEL SYSTEMFUEL DELIVERY-GASMODULE - FUEL PUMPREMOVALMODULE - FUEL PUMP

2008 Jeep Compass Limited, AWD, Standard

Module - Fuel Pump

2008 Jeep Compass Limited, AWD, StandardSECTION Module - Fuel Pump

WARNING: Release fuel system pressure before servicing fuel system components. Service vehicles in well ventilated areas and avoid ignition sources. Never smoke while servicing the vehicle. This may result in personal injury or death.

Perform FUEL SYSTEM PRESSURE RELEASE PROCEDURE .
Remove the air cleaner lid, disconnect the inlet air temperature sensor and makeup air hose.
Remove the negative battery cable.

Fig 1: Rear Seat In Place
Courtesy of CHRYSLER LLC
Remove the rear seat cushion.

Fig 2: Cushion Loose
Courtesy of CHRYSLER LLC
Rear seat cushion loose.

Fig 3: Module Cover
Courtesy of CHRYSLER LLC
Remove plastic cover.

Fig 4: Lock Ring Tool
Courtesy of CHRYSLER LLC
Clean top of tank to remove loose dirt and debris.
Use special tool #9340 to remove left side module lock ring.

Fig 5: Location Tab
Courtesy of CHRYSLER LLC
Note the fuel pump location on the top of the fuel tank.
NOTE: The pump has to be properly located to the tank for the fuel gauge to work properly.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.