Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMPASS 4WD L4-2.4LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSCHECK VALVESERVICE AND REPAIRINSTALLATION
2008 Jeep Compass 4WD L4-2.4L
Installation
2008 Jeep Compass 4WD L4-2.4LSECTION Installation
INSTALLATION
1. Position the rear check valve (2) between the upper liftgate opening header (1) and the headliner (5). Be certain that the raised arrow that indicates the flow direction on the center section of the valve is pointed toward the liftgate washer supply hose (6).
2. Reconnect the liftgate washer supply hose and the headliner washer supply hose (3) to the barbed nipples of the valve.
3. Reinstall the trim onto the right upper D-pillar (4). Installation.
4. Reconnect the battery negative cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.