Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMPASS 4WD L4-2.4LREPAIR AND DIAGNOSISSTARTING AND CHARGINGCHARGING SYSTEMALTERNATORSERVICE AND REPAIRGENERATOR - INSTALLATION
2008 Jeep Compass 4WD L4-2.4L
Generator - Installation
2008 Jeep Compass 4WD L4-2.4LSECTION Generator - Installation
INSTALLATION
1. Install the generator (1).
2. Rotate generator and set in place.
Make sure battery terminal (1) is in front of A/C line (2).
3. Install the upper mounting bolt.Tighten bolts to GAS 54 Nm (40 ft. lbs.).
4. Install the B+ terminal nut and wire and.Tighten to 10 Nm (88.5 in. lbs.)
5. Plug in the field circuit to the generator.
6. Install the lower mounting bolt.Tighten bolts to GAS 54 Nm (40 ft. lbs.).
7. Install the A/C compressor A/C Compressor - Installation.
8. Install the accessory drive idler pulley.Tighten bolt to 48 Nm (35 ft. lbs.).
9. Position back the serpentine belt .
10. Install the accessory drive splash shield.
11. Install underbody air dam.
12. Install the right front wheel.
13. Recharge the A/C system Refrigerant System Charge.
14. Connect the negative battery cable.
15. Install the air cleaner fresh air duct (2) and rotate the two retaining clips (3) to install.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.