Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMPASS 4WD L4-2.4LREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - TRANSMISSION AND DRIVETRAINRELAYS AND MODULES - TRANSFER CASECONTROL MODULELOCATIONS
2008 Jeep Compass 4WD L4-2.4L
Control Module: Locations
2008 Jeep Compass 4WD L4-2.4LSECTION Locations
Component ID: 188
Component : MODULE-ALL WHEEL DRIVE CONTROL
Connector:
Name : MODULE-ALL WHEEL DRIVE CONTROL
Color :
# of pins : 16
Qualifier : (AWD)
Pin Circuit Description
1 - -
2 - -
3 - -
4 D65 20WT/BK CAN C BUS (+)
5 F202 20PK/GY IGNITION SWITCH OUTPUT (RUN-START)
6 A923 20RD/WT FUSED B(+)
7 - -
8 T312 20YL/VT REAR DIFFERENTIAL SOLENOID CONTROL
9 - -
10 - -
11 - -
12 D64 20WT/LB CAN C BUS (-)
13 - -
14 - -
15 Z967 20BK GROUND
16 T78 20YL/BK SOLENOID SUPPLY VOLTAGE
Component Location - 38
Component Location - 40
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.