Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transmission Control Module - Installation
2008 Jeep Compass 4WD L4-2.4LSECTION Transmission Control Module - Installation
INSTALLATION
1. Install TCM mounting bracket holes (1) over the two studs on the bulkhead.
2. Install the two nuts to mounting studs (1) on the bulkhead and tighten to 15 Nm (130 in. lbs.).
3. Plug in electrical connectors (2) to TCM (3).
NOTE: If a new TCM is installed a learn procedure must be performed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.