Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMPASS 4WD L4-2.4LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMSPARK PLUGSERVICE AND REPAIRSPARK PLUG - REMOVAL
2008 Jeep Compass 4WD L4-2.4L
Spark Plug - Removal
2008 Jeep Compass 4WD L4-2.4LSECTION Spark Plug - Removal
REMOVAL
1. Disconnect the negative battery cable.
2. Disconnect the electrical connectors from ignition coils.
3. Remove the ignition coil mounting bolt.
4. Twist the ignition coil then pull straight up.
5. Remove the spark plug using a quality socket with a rubber or foam insert.
6. Inspect the spark plug condition.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.