Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMPASS 4WD L4-2.4LREPAIR AND DIAGNOSISDIAGRAMSCONNECTOR VIEWSBRAKE LIGHT SWITCH
2008 Jeep Compass 4WD L4-2.4L
Brake Light Switch
2008 Jeep Compass 4WD L4-2.4LSECTION Brake Light Switch
Component ID: 157
Component : SWITCH-STOP LAMP
Connector:
Name : SWITCH-STOP LAMP
Color : BLACK
# of pins : 6
Pin Circuit Description
1 A924 20DG/WT FUSED B(+)
Pin Circuit Description
1 A924 20RD FUSED B(+)
2 L53 20DG/WT STOP LAMP SWITCH OUTPUT
3 F202 18PK/GY IGNITION SWITCH OUTPUT (RUN-START)
4 B16 20LB/DG BRAKE SIGNAL 2
5 Z967 18BK/VT GROUND
6 B15 20DG/WT BRAKE SIGNAL 1
6 B15 20DG BRAKE SIGNAL 1
Component Location - 38
Component Location - 41
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.