Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Jeep Compass 4WD L4-2.4LFACTORY OEM SERVICE PROCEDURE
Installation
INSTALLATION
1. Install speed control switch (3) onto the locating pin (2) in the steering wheel. Make sure rubber seal is in place around switch.
2. Install speed control switch mounting screws (4) and tighten screws to 1.6 Nm (15 ins. lbs.).
3. Connect electrical connector (1) to speed control switch (3).
4. Install horn switch (2) to steering wheel.
5. Install horn switch mounting screws (3) and tighten screws to 8 Nm (71 ins. lbs.).
6. Install driver's side airbag Driver Airbag - Installation.
7. Connect negative battery cable, tighten nut to 5 Nm (45 in. lbs.).
8. Verify vehicle and system operation.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.