Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMPASS 4WD L4-2.0LREPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMIGNITION SWITCHSERVICE AND REPAIRINSTALLATION
2008 Jeep Compass 4WD L4-2.0L
Installation
2008 Jeep Compass 4WD L4-2.0LSECTION Installation
INSTALLATION
CAUTION: Carefully install the ignition switch to the slotted detent pin. If installed forcefully the detent pin will break the ignition cylinder lock housing will have to be replaced.
1. Pay close attention not to damage the detent pin in the lock cylinder housing when installing the ignition switch Position the ignition switch (1) as shown in order to clear the tilt lever (2).
2. Ensure the ignition module is in the RUN position and the actuator shaft in the lock housing is in the RUN position.
3. Align the ignition switch (1) with the detent pin (3), and retaining tabs (2) located on the lock cylinder housing. Carefully install the module, snapping it into place over the retaining tabs. Make sure the ignition switch is fully seated.
4. Install the ignition module (2) mounting screw (1). Tighten the screw to 2 Nm (18 in. lbs.).
5. Connect the ignition switch electrical connector.
6. Install upper (1) and lower (2) steering column shrouds,Installation.
7. Install air cleaner fresh air duct (2) and disconnect and isolate negative battery cable at battery, Battery - Installation.
8. Check operation of all steering column mounted components.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.