Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMPASS 4WD L4-2.0LREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTANTITHEFT AND ALARM SYSTEMSALARM MODULESERVICE AND REPAIRINTRUSION MODULE - INSTALLATION
2008 Jeep Compass 4WD L4-2.0L
Intrusion Module - Installation
2008 Jeep Compass 4WD L4-2.0LSECTION Intrusion Module - Installation
INSTALLATION
1. Position the Intrusion Transceiver Module (ITM) (1) to the mounting hole in the headliner.
2. Reconnect the wire harness connectors to the ITM and rear dome lamp connector receptacles on the back of the ITM.
3. Insert the fixed retainer on the left side of the ITM housing up into the left side of the mounting hole in the headliner.
4. Slide the notched end (4) of the housing into the mounting hole far enough to engage the rear dome lamp lens hinge/retainer into the opposite side of the hole in the headliner.
5. Gently and evenly press the lens hinge/retainer end of the lamp into the mounting hole until the bezel of the ITM housing is flush with the headliner.
6. Swing the notched end of the lamp lens (2) into position against the lamp housing, then press upward on the lens firmly and evenly until it snaps into the housing.
7. Reconnect the battery negative cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.