Service Procedure

NOTE:
Use StarSCAN(R) to perform this Customer Satisfaction Notice. This procedure must be performed using software release 8.02 or higher.
Re-Configure the TIPM using StarSCAN(R)

1. Open the hood. Install a battery charger and verify that the charging rate provides 13.0 to 13.5 volts. Do not allow the charger to time out during the process. Set the battery charger timer (if so equipped) to continuous charge.

NOTE:
Use an accurate stand alone voltmeter. The battery charger voltmeter may not be sufficiently accurate. Voltages outside of the specified range will cause an unsuccessful flash. If voltage reading is too high, apply an electrical load by activating the park or headlamps and/or HVAC blower motor to lower the voltage.

2. Connect the CH9410 StarSCAN(R) Ethernet cable to the StarSCAN(R) and the dealer's network drop.

3. Connect the CH9404 StarSCAN� vehicle cable to the StarSCAN(R) and the vehicle.

4. Place the Ignition in the "RUN" position, then Power "ON" the StarSCAN(R).

5. Re-Configure the TIPM as Follows:

a. With the StarSCAN(R) on the "Home" screen, select "ECU View".

b. Select "TIPMCGW Central Gateway" in the list of modules.

c. Select "Misc Functions".

d. Select "Restore Vehicle Configuration".

e. Press "Start".

f. Follow the prompts listed on the StarSCAN(R).

g. When prompted, Enter the full 17 digit VIN found on the VIN plate.

NOTE:
Assure the correct VIN is input into the StarSCAN(R).

h. Select "Next".

NOTE:
The StarSCAN(R) must be connected to the dealer network drop.

i. Follow the prompts listed on the StarSCAN(R).

6. Check and clear any Diagnostic Trouble Codes (DTC's) that may have been set.

7. Turn the ignition key to the "OFF" position and remove the StarSCAN(R) unit, StarSCAN(R) cable, and battery charger from the vehicle.