Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Jeep Compass 2WD L4-2.0LFACTORY OEM SERVICE PROCEDURE
Brake Fluid: Service and Repair
BRAKE FLUID LEVEL CHECKING
NOTE: Brake fluid level should be checked a minimum of twice a year.
Master cylinder reservoirs (2) are marked, FULL and ADD, indicating the allowable brake fluid level range in the master cylinder fluid reservoir.
CAUTION: Use only Mopar(R) Brake Fluid DOT 3 Motor Vehicle or equivalent from a tightly sealed container. Do not use petroleum-based fluid because seal damage in the brake system will result.
NOTE: Although there is a range, the preferred level is FULL.
1. Remove the cap (1).
2. Adjust the brake fluid level to the FULL mark listed on the side of the master cylinder fluid reservoir (2) as necessary. Do not overfill the system.
3. Install the cap (1).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.