Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Jeep Compass 2WD L4-2.0LFACTORY OEM SERVICE PROCEDURE
Steering Angle Sensor, Traction Control
Component ID: 189
Component : SENSOR-STEERING ANGLE
Connector:
Name : SENSOR-STEERING ANGLE
Color : WHITE
# of pins : 4
Pin Circuit Description
1 D65 20WT/BK CAN C BUS (+)
2 D64 20WT/LB CAN C BUS (-)
3 Z936 20BK/LB GROUND
3 Z937 20BK/YL GROUND
4 F202 18PK/GY IGNITION SWITCH OUTPUT (RUN-START)
Component Location - 27
Component Location - 28
Component Location - 30
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.