2008 Jeep Commander Overland, RWDFACTORY OEM SERVICE PROCEDURE

Intrusion Module: Removal

Fig 1: Intrusion Module
GC0045725Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. Fold and tumble the right outboard second row seat assembly forward.
  3. Remove the carpeted cover panel from over the cavity on the right outboard end of the intermediate step assembly (1).
  4. Disconnect the body wire harness connector (3) from the intrusion module (2) connector receptacle.
  5. Using a trim stick or another suitable wide flat-bladed tool, gently pry the two latch features on the floor of the intermediate step cavity away from the mounting tabs of the module far enough to disengage the module.
  6. Disengage the two mounting tabs on the sides of the module from the slots in the intermediate step cavity.
  7. Remove the module from the cavity in the intermediate step assembly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.