Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Jeep Commander Overland, 4WDFACTORY OEM SERVICE PROCEDURE
Shock Spring
| 1 - SPRING COMPRESSOR |
| 2 - SPRING |
- Remove the shock. See REMOVALĀ .
- Install the shock assembly in the Branick 7200Ā® spring removal/installation tool or equivalent (1).
- Compress the spring (2).
- Remove the upper shock nut (2).NOTE: The nub (1) in the upper shock mount (3) must be 180° from the centerline of the lower bracket (9) on the shock (8) for proper installation.
- Remove the shock (8).
- Remove the shock upper mount (3).
- Remove and inspect the upper (5) and lower (7) spring isolators.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- ⢠You smell fuel, burning insulation, or see smoke.
- ⢠Brakes feel soft, pull hard to one side, or make grinding noises.
- ⢠The engine overheats, stalls repeatedly, or misfires under load.
- ⢠You are missing required tools, torque specs, or safe lifting equipment.
- ⢠You are not confident in the next step or safety outcome.
