Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMMANDER LIMITED, 5.7 2, 4WDREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMDTCS P0128 TO P0197
2008 Jeep Commander Limited, 5.7 2, 4WD
DTCS P0128 To P0197
2008 Jeep Commander Limited, 5.7 2, 4WDSECTION DTCS P0128 To P0197
- P0128-Thermostat Rationality
- P0129-Barometric Pressure Out-Of-Range Low
- P0131-O2 Sensor 1/1 Circuit Low
- P0132-O2 Sensor 1/1 Circuit High
- P0133-O2 Sensor 1/1 Slow Response
- P0135-O2 Sensor 1/1 Heater Performance
- P0137-O2 Sensor 1/2 Circuit Low
- P0138-O2 Sensor 1/2 Circuit High
- P0139-O2 Sensor 1/2 Slow Response
- P013A-O2 Sensor 1/2 Slow Response - Rich To Lean
- P013C-O2 Sensor 2/2 Slow Response - Rich To Lean
- P0141-O2 Sensor 1/2 Heater Performance
- P0151-O2 Sensor 2/1 Circuit Low
- P0152-O2 Sensor 2/1 Circuit High
- P0153-O2 Sensor 2/1 Slow Response
- P0155-O2 Sensor 2/1 Heater Performance
- P0157-O2 Sensor 2/2 Circuit Low
- P0158-O2 Sensor 2/2 Circuit High
- P0159-O2 Sensor 2/2 Slow Response
- P0161-O2 Sensor 2/2 Heater Performance
- P0171-Fuel System 1/1 Lean
- P0172-Fuel System 1/1 Rich
- P0174-Fuel System 2/1 Lean
- P0175-Fuel System 2/1 Rich
- P0196-Engine Oil Temperature Sensor Performance
- P0197-Engine Oil Temperature Sensor Circuit Low
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.