Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMMANDER BASE, 4.7 N, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSSPEED CONTROLSWITCH-SPEED CONTROLINSTALLATIONSPEED CONTROL SWITCH
2008 Jeep Commander Base, 4.7 N, AWD
Speed Control Switch
2008 Jeep Commander Base, 4.7 N, AWDSECTION Speed Control Switch
- Position switch (2) to steering wheel.
- Install switch mounting screw (1) and tighten. Refer to TORQUE CHART .
- Plug electrical connector into switch.
- Install airbag module. Refer to RESTRAINTS - SERVICE INFORMATION article.
- Connect negative battery cable to battery.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.