Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Jeep Commander Base, 3.7 K, RWDFACTORY OEM SERVICE PROCEDURE
Module-Remote Compass: Removal
- Disconnect and isolate the battery negative cable.
- Partially remove the headliner (1) to gain access to the Remote Compass Module (RCM) (2). Refer to REMOVAL for the appropriate procedure.
- Disconnect the RCM electrical connector (3).
- Remove the RCM retaining screws (4).
- Remove the RCM (2) from the vehicle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.