Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMMANDER BASE, 3.7 K, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEFRAMES, SUBFRAMES & CROSSMEMBERSFRAME & BUMPERSFRAMECROSSMEMBER-REAR/TRANSMISSIONINSTALLATIONCROSSMEMBER-REAR/TRANSMISSION
2008 Jeep Commander Base, 3.7 K, RWD
Frame & Bumpers: Frame: CROSSMEMBER-Rear/Transmission: Installation: CROSSMEMBER-Rear/Transmission
2008 Jeep Commander Base, 3.7 K, RWDSECTION CROSSMEMBER-Rear/Transmission
- Install the crossmember and install the eight crossmember bolts (2).
- Tighten the crossmember bolts to 54 N.m (40 ft. lbs.).
- Remove the lifting device.
- Install the four transmission mount bolts (1) and tighten to 54 N.m (40 ft. lbs.).
- Install the skid plate. See INSTALLATION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.