Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMMANDER BASE, 3.7 K, AWDREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMDTCS P0606 TO P0700
2008 Jeep Commander Base, 3.7 K, AWD
DTCS P0606 To P0700
2008 Jeep Commander Base, 3.7 K, AWDSECTION DTCS P0606 To P0700
- P0606-Internal ECM Processor
- P060B-Etc A/D Ground Performance
- P060D-Etc Level 2 App Performance
- P060E-Etc Level 2 TPS Performance
- P060F-Etc Level 2 ECT Performance
- P061A-Etc Level 2 Torque Performance
- P061C-Etc Level 2 Rpm Performance
- P0622-Generator Field Control Circuit
- P0627-Fuel Pump Relay Circuit
- P062C-Etc Level 2 Mph Performance
- P0630-VIN Not Programmed In Pcm
- P0632-Odometer Not Programmed In Pcm
- P0633-Skim Secret Key Not Stored In Pcm
- P063A-Generator Voltage Sense Circuit
- P0642-Sensor Reference Voltage 1 Circuit Low
- P0643-Sensor Reference Voltage 1 Circuit High
- P0645-A/C Clutch Relay Circuit
- P0652-Sensor Reference Voltage 2 Circuit Low
- P0653-Sensor Reference Voltage 2 Circuit High
- P0685-Auto Shutdown Relay Control Circuit
- P0688-Auto Shutdown Relay Sense Circuit Low
- P0691-Cooling Fan 1 Relay Control Circuit Low
- P0692-Cooling Fan 1 Relay Control Circuit High
- P0693-Cooling Fan 2 Relay Control Circuit Low
- P0694-Cooling Fan 2 Relay Control Circuit High
- P0700-Transmission Control System (Mil Request)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.