2008 Jeep Commander 4WD V8-5.7LFACTORY OEM SERVICE PROCEDURE

Component ID 207




Component ID: 207
Component : MODULE-FINAL DRIVE CONTROL

Connector:
Name : MODULE-FINAL DRIVE CONTROL C1
Color :
# of pins : 26
Qualifier : (45RFE)
Factory service manual diagram




Pin Circuit Description
1 A926 18RD/TN FUSED B(+)
2 - -
3 Z901 18BK GROUND
4 - -
5 - -
6 - -
7 - -
8 - -
9 - -
10 - -
11 A909 16RD FUSED B(+)
12 T316 16YL/GY SHIFT MOTOR CONTROL B
13 T315 16YL/BR SHIFT MOTOR CONTROL A
14 T301 20DG/YL SWITCHED BATTERY SOLENOID SUPPLY
15 Z913 16BK GROUND
16 - -
17 T317 20YL/TN TRANSFER CASE MOTOR LOCK SIGNAL
18 - -
19 - -
20 - -
21 - -
22 T306 20DG/DB FRONT DIFFERENTIAL SOLENOID CONTROL
23 T312 20YL/VT REAR DIFFERENTIAL SOLENOID CONTROL
24 A927 18RD/BR FUSED B(+)
25 - -
26 Z913 16BK GROUND

Component Location - 68
Factory service manual diagram






Connector:
Name : MODULE-FINAL DRIVE CONTROL C2
Color :
# of pins : 16
Qualifier : (45RFE)
Factory service manual diagram




Pin Circuit Description
1 - -
2 G95 20VT/WT 4WD NEUTRAL INDICATOR
2 G95 20VT/BR 4WD NEUTRAL INDICATOR
3 K977 20BR/LB MODE SELECT
3 K977 20BR/WT MODE SELECT
4 - -
5 T313 20YL/LG MODE SENSOR SIGNAL
6 - -
7 - -
8 - -
9 Z902 18BK GROUND
10 F921 20PK/GY FUSED RUN RELAY OUTPUT
10 F921 20PK/YL FUSED RUN RELAY OUTPUT
11 D65 20WT/LG CAN C BUS (+)
12 D64 20WT/LB CAN C BUS (-)
13 - -
14 - -
15 K504 20BR DRIVETRAIN 5 VOLT SUPPLY
16 K594 20BR/LG DRIVETRAIN SENSOR RETURN

Component Location - 68
Factory service manual diagram






Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.