2008 Jeep Commander 4WD V8-4.7LFACTORY OEM SERVICE PROCEDURE

Switch-Window/Door Lock-Driver




Component ID: 591
Component : SWITCH-WINDOW/DOOR LOCK-DRIVER

Connector:
Name : SWITCH-WINDOW/DOOR LOCK-DRIVER C1
Color :
# of pins : 8
Factory service manual diagram




Pin Circuit Description
1 A929 16RD/DB FUSED RUN/ACCESSORY DELAY RELAY OUTPUT
2 Q611 16OR/GY MASTER WINDOW SWITCH LEFT REAR (DOWN)
3 Q411 16OR/WT MASTER WINDOW SWITCH LEFT REAR (UP)
4 Q612 16OR/DB MASTER WINDOW SWITCH RIGHT REAR (DOWN)
5 Q15 16OR/LB WINDOW LOCK OUT SWITCH OUTPUT
6 Z911 16BK GROUND
7 - -
8 Q412 16OR/LB MASTER WINDOW SWITCH RIGHT REAR (UP)

Component Location - 65
Factory service manual diagram






Connector:
Name : SWITCH-WINDOW/DOOR LOCK-DRIVER C2
Color :
# of pins : 6
Factory service manual diagram




Pin Circuit Description
1 Q221 20OR/DG MASTER SWITCH LEFT FRONT WINDOW MUX
2 Q222 20OR/GY MASTER SWITCH RIGHT FRONT WINDOW MUX
3 G161 20VT/DG LEFT DOOR LOCK SWITCH MUX
3 G160 20VT/LG RIGHT DOOR LOCK SWITCH MUX
4 Q994 20BK/BR DRIVER EXPRESS WINDOW SWITCH RETURN
5 G775 20OR/VT LEFT DOOR LOCK SWITCH RETURN
5 G776 20VT/OR RIGHT DOOR LOCK SWITCH RETURN
6 - -

Component Location - 65
Factory service manual diagram






Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.