Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMMANDER 4WD V8-4.7L FLEX FUELREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSBODY CONTROL MODULESERVICE AND REPAIRMODULE-DOORREMOVAL
2008 Jeep Commander 4WD V8-4.7L Flex Fuel
Removal
2008 Jeep Commander 4WD V8-4.7L Flex FuelSECTION Removal
DOOR (MEMORY) MODULE REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Remove the door panel, Service and Repair
3. First disconnect the black 10-way electrical connector (1), then the brown 20-way electrical connector (2). If applicable, next disconnect the black 12-way electrical connector (3) from the module.
4. Remove fasteners and module from vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.