Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMMANDER 2WD V8-5.7LREPAIR AND DIAGNOSISDIAGRAMSCONNECTOR VIEWSBRAKE LIGHT SWITCH
2008 Jeep Commander 2WD V8-5.7L
Brake Light Switch
2008 Jeep Commander 2WD V8-5.7LSECTION Brake Light Switch
Component ID: 587
Component : SWITCH-STOPLAMP
Connector:
Name : SWITCH-STOPLAMP
Color : GRAY
# of pins : 6
Pin Circuit Description
1 A103 18GY/RD FUSED B(+)
2 L50 18WT/TN BRAKE LAMP SWITCH OUTPUT
3 F942 20PK/LG FUSED IGNITION SWITCH OUTPUT (RUN-START)
4 B16 20LB/DG BRAKE SWITCH NO. 2 SIGNAL
5 Z904 20BK GROUND
6 B15 20DG/WT BRAKE SWITCH NO. 1 SIGNAL
Component Location - 3
Component Location - 4
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.