Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMMANDER 2WD V8-4.7LREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - BODY AND FRAMEPEDAL POSITIONING MODULETESTING AND INSPECTION
2008 Jeep Commander 2WD V8-4.7L
Pedal Positioning Module: Testing and Inspection
2008 Jeep Commander 2WD V8-4.7LSECTION Testing and Inspection
ADJUSTABLE PEDALS MODULE (APM)
In order to obtain conclusive testing of the adjustable pedals system, the Controller Area Network (CAN) data bus, and all of the electronic modules that provide inputs to, or receive outputs from the adjustable pedals system components must be checked. Any diagnosis of the adjustable pedals module should begin with the use of a scan tool and the appropriate diagnostic service information.
Refer to the appropriate wiring information for complete circuit schematic or connector pin-out information.
Before any testing of the adjustable pedals system is attempted, the battery should be fully-charged.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.